222 Management: Installing Array ComponentsInstalling a RAID Controller ModuleCAUTION: Many repairs may only be done by a certified service technician. Youmust only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not coveredby your warranty. Read and follow the safety instructions that came with theproduct.1 Insert the RAID controller module into the RAID controller module bayuntil it seats into place.2 Push the release lever toward the chassis until it clicks into place.3 Connect all the cables to the RAID controller module.4 If applicable, update the firmware for the RAID controller module. Forinformation about the latest firmware, see support.dell.com.Opening the RAID Controller ModuleCAUTION: Many repairs may only be done by a certified service technician. Youmust only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not coveredby your warranty. Read and follow the safety instructions that came with theproduct.1 Turn off the array and host server.2 Disconnect all the power cables connected to the array.3 Remove the RAID controller module. See "Removing a RAID ControllerModule Blank" on page 219.4 Remove the screws from the sides of the RAID controller module. SeeFigure 16-9.5 While pressing the indent, slide the cover in the direction of the arrow andlift it away from the RAID controller module. See Figure 16-9.
