Vendor Identification:Eight byte ASCII string. This field is set to:0 1 2 3 4 5 6 7I B MProduct Identification:Sixteen byte ASCII string. This field depends on the library model. This field is set to:0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 153 5 7 3 - T LProduct Revision Level:This field contains 4 bytes of ASCII data that provides the media changer's software revisionlevels. When a firmware update is performed on the media changer, this part of the revision levelchanges to reflect that update.BarC: When set this bit indicates that the library is equipped with a bar code scanner.IUS: Information Units Supported. Set to 0 indicating information units are not supported.QAS: Quick Arbitrate Supported. Set to 0 indicating QAS is not supported.Clocking:Indicates the level of data clocking supported. Set to 11b if the host interface speed has not beenset to limit transfers to 80MB/s. Set to 00b when the host interface speed has been set to limittransfers to 80 MB/s.Version Descriptors:The version descriptors report the identifier of the supported SCSI command sets.Supported Vital Product Data page (00h)The Supported Vital Product Data VPD page provides a directory of the Vital Product Data Pages that aresupported by the media changer.Bit 7 6 5 4 3 2 1 0Byte0 Peripheral Qualifier (0) Peripheral Device Type (8)1 Page Code (00h)2 Reserved3 Page Length (04h)4 00h - (this page)5 80h - Unit Serial Number Page6 83h - Device Identification Page7 C0h - Firmware Build Information Page8 D0h - Vendor Specific Page9 FFh - Vendor Use OnlyNote: If an unsupported LUN was initially specified, the Peripheral Qualifier will return 3h and thePeripheral Device Type will return 1Fh.Chapter 3. Supported SCSI Commands 3-7
