Table 8-1. Error CodesError Code Description User Action30 SCSI: transport element fullCheck the application software.31 SCSI: all slots empty32 SCSI: invalid opcode33 SCSI: invalid element address34 SCSI: invalid field in CDB35 SCSI: Invalid drive specified36 SCSI: SEND DIAGNOSTIC command:invalid test number37 SCSI: invalid LUN38 SCSI: parameter list length error39 SCSI: parameter list error: invalid field3A SCSI: parameter list error: parameter notsupported3B SCSI: parameter value invalid3C SCSI: saving parameters not supported3D SCSI: invalid ID message3E SCSI: destination element full3F SCSI: source slot or drive empty40 SCSI: wrong checksum41 SCSI: command sequence error42 SCSI: drive disabled Check your configuration settings.43 SCSI: mailslot disabled44 SCSI: flash image does not fit bootcodeCheck the application software.45 SCSI: media removal prevented by drive46 SCSI: media removal prevented bylibrary47 SCSI: flash image does not fit personality Check the version of code used for the upgrade.48 SCSI: drive type not supported in thislibraryCheck if a version of code is available which supports thisdrive type.49 SCSI: incompatible magazine, magazinenot accessible Check your configuration settings.4A SCSI: source not ready Complete move process and retry operation.4B SCSI: destination source not ready4C SCSI: library controller busy Complete process and retry operation.4D SCSI: cannot make reservationCheck application software.4E SCSI: invalid slave robotic controllerrequest4F SCSI: robotic axes/motors aren’tinitialized Check robotics status.8-2 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide