backup and recovery. These settings are required for Library ManagedEncryption only. Enter the EKM Server Setting information.v Primary IP address (IPv4 or IPv6): Enter the IP address of the primary EKMserver.v Primary TCP port: After entering the Primary IP address, the library willautomatically set the value of the Primary TCP port.v Secondary IP address (IPv4 or IPv6): Enter the IP address of the secondaryEKM server.v Secondary TCP port: After entering the Secondary IP address, the librarywill automatically set the value of the Secondary TCP port.Note: The Default Port for TCP (SSL disabled) is 3801. The Default Port forSSL is 443. These values are the default values set by the library. Theycan be changed depending on the user configuration but the user hasto make sure they match the EKM properties file.Note: If SSL is enabled the encryption host configuration will request a SSLport instead of a TCP port. Review your Dell PowerVault EncryptionKey Manager User’s Guide for instructions to locate the appropriate portsettings.8. Click Activate to apply the changes.9. Install the Dell Encryption Key Manager (EKM) application on your host. Referto the Dell EKM documentation provided with your Encryption packet. TheEKM IP address and EKM port will be provided to the user by the EKMapplication.Choosing Drive(s) Interface Identification/Settings1. Click Drives in the left navigation pane.2. Select the desired settings for each drive listed (either SCSI, SAS, or FibreChannel). See Figure 4-26.3. Click one of the following:v Refresh - to update the current screenv Submit - to apply the changes made to the screena77ug095Figure 4-26. The Configure Library: Drive screenChapter 4. Installation and Configuration 4-23
