116 Removing and Installing Parts6 Replace the drive panel (see "Replacing the Drive Panel" on page 105).7 Replace the computer cover (see "Replacing the Computer Cover" on page 125).NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into thecomputer.8 Connect the computer and devices to electrical outlets, and turn them on.Installing a CD/DVD Drive1 Follow the procedures in "Before You Begin" on page 75.2 Remove the computer cover (see "Removing the Computer Cover" on page 76).3 Remove the drive panel (see "Removing the Drive Panel" on page 104).4 Remove the existing CD/DVD drive, if applicable (see "Removing a CD/DVD Drive" on page 114).5 Prepare the CD/DVD drive for installation and check the documentation that accompanied the driveto verify that the drive is configured for your computer.NOTE: If you are installing an IDE drive, configure the drive for the cable select setting.1 drive release latch 2 CD/DVD drive12book.book Page 116 Thursday, July 20, 2006 11:10 AM
