Using iDRAC6 Configuration Utility 307Press to select the item. The following warning message appears:Resetting to factory defaults will restore remote Non-Volatile user settings. Continue?< NO (Cancel) >< YES (Continue) >To reset iDRAC6 to the defaults, select YES and press .System Event Log MenuThe System Event Log Menu allows you to view System Event Log (SEL)messages and to clear the log messages. Press to display the SystemEvent Log Menu. The system counts the log entries and then displays thetotal number of records and the most recent message. The SEL retains amaximum of 512 messages.To view SEL messages, select View System Event Log and press .To navigate:• Use the left-arrow key to move to the previous (older) message and theright-arrow key to move to the next (newer) message.• Enter a specific record number to jump to that record.Press to exit the System Event Log.NOTE: You can only clear the SEL in iDRAC6 Configuration Utility or in iDRAC6 Webinterface.To clear the SEL, select Clear System Event Log and press .When you have finished with the SEL menu, press to return to theprevious menu.Exiting iDRAC6 Configuration UtilityWhen you have finished making changes to iDRAC6 configuration, press the key to display the Exit menu.Select Save Changes and Exit and press to retain your changes.Select Discard Changes and Exit and press to ignore any changesyou made.Select Return to Setup and press to return to iDRAC6Configuration Utility.
