44 Configuring iDRAC6 Enterprise• Chassis LCD Panel — See the Dell Chassis Management ControllerFirmware User Guide• iDRAC6 Configuration Utility — See "Using iDRAC6 ConfigurationUtility"• CMC Web interface — See "Configuring Networking Using the CMCWeb Interface"• Remote and local RACADM — See "cfgLanNetworking"Configure iDRAC6 UsersSet up the local iDRAC6 users and permissions. iDRAC6 holds a table ofsixteen local users in firmware. You can set usernames, passwords, and rolesfor these users.NOTE: <, >, and \ are not allowed in usernames or passwords.• iDRAC6 Configuration Utility (configures administrative user only) —See "LAN User Configuration"• iDRAC6 Web interface — See "Adding and Configuring iDRAC6 Users"• Remote and local RACADM — See "Adding an iDRAC6 User"NOTE: When using iDRAC6 in an Active Directory environment, the user names youcreate must conform to the Active Directory naming convention in force.Configure Active DirectoryIn addition to the local iDRAC6 users, you can use Microsoft® ActiveDirectory® to authenticate iDRAC6 user logins.For more information, see "Using iDRAC6 With Microsoft Active Directory."NOTE: When using iDRAC6 in an Active Directory environment, be sure your usernames conform to the Active Directory naming convention in force.Configure IP Filtering and IP BlockingIn addition to user authentication, you can prevent unauthorized access byrejecting connection attempts from IP addresses outside of a defined rangeand by temporarily blocking connections from IP addresses whereauthentication has failed multiple times within a configurable timespan.• iDRAC6 Web interface — See "Configuring IP Filtering and IP Blocking"
