Denon AVR-2106 Operating Instructions Manual

Also see for AVR-2106: Control protocol Operating instructions Brochure & specs Operating instructions Service manual

36Advanced Setup – Part 1 Advanced Setup – Part 1• The OPTICAL 3 terminal on the AVR-2106’s rear panel isequipped with an optical digital output terminal for recordingdigital signals on a CD recorder, MD recorder or other digitalrecorder. Use this for digital recording between a digital audiosource (stereo – 2 channels) and a digital audio recorder.• Do not connect the output of the component connected to theOPTICAL 3 OUT terminal on the AVR-2106’s rear panel to anyterminal other than the OPTICAL 3 IN terminal.• “PHONO”, “TUNER” and “V. AUX” cannot be selected with“Digital In Assignment”.2 Press the CURSOR DD or HH button to select“Digital In Assign.”, then press the ENTERbutton.• The “Digital In Assign.” screen appears.3 Press the CURSOR DD or HH button to select thedigital input terminal, then press the CURSORFF or GG button to select the input source.Select “OFF” for input sources for which no digital inputterminals are used.If “Yes” is selected for “Default”, the settings areautomatically reset to the default values.4 Press the ENTER button to enter the setting.• The “Input Setup” menu appears.This setting assigns the digital input terminals of the AVR-2106for the different input sources.Input SetupSetting the Digital In Assign.1 Press the CURSOR DD or HH button to select“Input Setup” at the “System Setup” menu,then press the ENTER button.• The “Input Setup” menu appears.Set the method of playback of the analog input signal connectedto the Ext. In Subwoofer.Setting the Ext In SW Level1 Press the CURSOR DD or HH button to select “ExtIn SW Level” at the “Input Setup” menu, thenpress the ENTER button.• The “Ext In SW Level” screen appears.2 Press the CURSOR FF or GG button to selectaccording to the specifications of the playerbeing used.Also refer to the player’s operating instructions.+15 dB (default) recommended (0, +5, +10 or +15 can beselected).3 Press the ENTER button to enter the setting.• The “Input Setup” menu appears.• Correct the playback level of the different input sources.• Adjust the playback levels of the devices connected to thedifferent input sources to the same level to eliminate the needfor adjusting the main volume each time the input source isswitched.Setting the Input Function Level1 Press the CURSOR DD or HH button to select“Input Function Level” at the “Input Setup”menu, then press the ENTER button.• The “Input Function Level” screen appears.2 Press the CURSOR DD or HH button to select theinput source, then press the CURSOR FF or GGbutton to adjust the level.The level can be adjusted between –12 dB and +12 dB inunits of 1 dB.If “Yes” is selected for “Default”, the settings areautomatically reset to the default values.3 Press the ENTER button to enter the setting.• The “Input Setup” menu appears.• After completing this setting, check that the playback levels forthe different sources are the same.