Denon AVR-4310 Owner's Manual

Also see for AVR-4310: Service manual Owner's manual

Contents

Denon AVR-4310 Owner's Manual Manual pdf 95 page image

Getting Started Connections Settings Playback Multi-zone Information Troubleshooting SpecificationsENGLISHOperating the Main Remote Control UnitWith some remote control units, the signals cannot be learned or thedevice will not operate properly even when the signals have beenlearned. In this case, use the device’s own remote control unit.Learned buttons have priority over the preset memory. If you nolonger need the learned setting, reset the learning function (vpage93).••NOTE[POWER ON], [POWER OFF] and [SOURCE SELECT] cannot belearned.Do not learn any remote control signals at [RC SETUP].The MAIN, ZONE2, ZONE3, ZONE4 and MACRO modes cannot belearned.Codes cannot be learned at [MASTER VOLUME] or [MUTE] whenthe main remote control unit is set to “TUNER”, “SAT TU”, “DTU”,“NET/USB” or “iPod”.••••This function lets you register a series of operations at a singlebutton.For example, the amplifier can be turned on, the input source selected,the monitor’s power turned on, the source device’s power turned onand the play mode set all by pressing a single button.Up to 32 signals each can be registered at [MACRO] (1 ~ 3).MACRO Function1 Press and hold in [RC SETUP] for at least 3 seconds.The signal transmission indicator flashes twice.2 Press [9], [7] and [8], in that order.The signal transmission indicator flashes twice and the systemcall registration mode is set.3 Press [MACRO] (1 ~ 3) at which you want to registerthe signals.4 Press the buttons you want to register in the samesequence as the operations you want to perform.The signal transmission indicator lights when a button ispressed.Example : Press [POWER ON].↓Press [DEVICE SELECTOR] – [DVD/HDP].↓Press [1].The mode can be switched by pressing [DEVICE SELECTOR].Perform the registration procedure for all the buttons you wantto register.bb5 Press and hold in [RC SETUP] for at least 3 seconds.The signal transmission indicator flashes twice and the settingis completed.NOTERegistration is not possible in ZONE2, ZONE3, ZONE4 and MACROmodes.RegisteringCalling outDVD/HDP (including BD and CD) or DVR/VCR mode buttons can bestored at unused TV or SAT/CBL mode buttons.For example, when DVD mode buttons are assigned to the TV mode,the DVD mode operations can be performed while in the TV mode.Punch Through Function1 Press [MAIN], to select “MACRO”.2 Press [MACRO] (1 ~ 3) at which the signals wereregistered.The registered signals are transmitted in the registeredsequence.1 Press and hold in [RC SETUP] for at least 3 seconds.The signal transmission indicator flashes twice.2 Press [9], [8] and [4], in that order.The signal transmission indicator flashes twice and the punchthrough setting mode is set.3 Press [DEVICE SELECTOR] for the device you want topunch through ([DVD/HDP] or [VCR/DVR]).4 Press the button you want to punch through ([1],[2], [6], [7], [8], [9] or [3]).Each time the button is pressed, the signal transmissionindicator flashes once.5 Press [DEVICE SELECTOR] for the device you want topunch through ( [TV] or [SAT/CBL]).6 Press and hold in [RC SETUP] for at least 3 seconds.The signal transmission indicator flashes twice and the settingis completed.Remote Control