Denon AVR-989 Owner's Manual

Also see for AVR-989: Product Compatibility Chart Service manual Comparison chart Getting started Test reports

Denon AVR-989 Owner's Manual Manual pdf 22 page image

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting SpecificationsRLRL"6%*03-*/*/7*%&0"6%*07*%&0"69065Multi-zoneZONE2 Pre-out Connections• If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 pre-out (variable orfixed level) connectors can be used to play a different program source in ZONE2 the same time (vpage67 ~ 69).• When using an S-Video cable or a video cable for connection between the AVR-989 and an input device,connect to the video connectors.Input OutputInfraredretransmitterInfraredsensorNOTE• For the audio output, use high quality pin-plug cords so that no induction humming or noise is produced.• For instructions on installing and operating separately sold devices, refer to the respective devices’operating instructions.• To conduct multi-zone playback, see “Amp Assign / Multi-zone Connections and Operations” (vpage65, 66).External Controller• When using in combination with an RF RemoteController (RC-7000CI, sold separately) or RFRemote Receiver (RC-7001RCI, sold separately)two-way communication with an RF RemoteController is possible.The AVR-989’s status information as well asiPod can be browsed watching the RF RemoteController’s display. For details, refer to theoperating instructions of the respective devices.• When used in combination with an RF RemoteController or RF Remote Receiver, make thesettings at menu “Manual Setup” – “OptionSetup” – “232C Port” – “2Way Remote”(vpage 34).• On the menu, when setting “Manual Setup”– “Option Setup” – “232C Port” to “2WayRemote”, you cannot use the RS-232C connectoras an external controller (vpage 34).RS-232C connectorThis connector is used for an external controller.b If you wish to control the AVR-989 froman external controller using the RS-232Cconnector, perform the operation belowbeforehand.q Turn on the AVR-989’s power.w Turn off the AVR-989’s power from the externalcontroller.e Check that the AVR-989 is in the standbymode.Trigger output jackThe power of an external device equipped witha trigger input jack can be turned on and off inassociation with operations on the AVR-989. Fordetails, see menu “Manual Setup” – “OptionSetup” – “Trigger Out” (vpage 34).• Output: DC 12 V 150 mA MAX.Check the trigger input conditions of theconnected device.Monitor (ZONE2)Extension jack for future use.(Connect devices correspondingwith room to room function tothis jack.)Pre-main amplifier(ZONE2)Connections