Denon AVR-989 Owner's Manual

Also see for AVR-989: Product Compatibility Chart Service manual Comparison chart Getting started Test reports

Denon AVR-989 Owner's Manual Manual pdf 58 page image

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting SpecificationsSearching Categories1 Press o p.SR001 Hits 1CAT : Pops2 Use o p to select the category, to use ui to selectthe desired channel.Channel category• “UPDATING” is displayed while the encording code is beingupdated.• “SIRIUS UPDATING” is displayed when updating SIRIUS tunerfi rmware.• Refer to “Troubleshooting” – “SIRIUS Satellite Radio” regarding othermessages (vpage 79).Parental Lock1 Tune to the channel you want to lock.2 Press [ENTER] for at least 3 seconds.“Code: [ ]” is displayed.3 Enter the 4-digit lock code using uio p.When you enter the correct code, the corresponding channel islocked.4 Press [ENTER].• Channels under Parental Lock cannot be tuned in by performingTuning Up/Down or by category search.• Channels stored in preset memory can be tuned in by the presetchannel select operation, even if Parental Lock is applied.• When a channel to which Parental Lock is applied is being played,Parental Lock for that channel is cancelled by performing Step 2.• See “Edit Lock Cord” (vpage 39) for the method of changingParental Lock Cord.• You can also set “Parental Lock” from the menu. (vpage 39).iPod® PlaybackThe music on an iPod can be played by using the control dock foriPod (ASD-1R, ASD-3N or ASD-3W sold separately).The operation can also be performed using the buttons on the mainunit or remote control unit while watching the menus.iPod is a trademark of Apple Inc., registered in the U.S.and other countries.b The iPod may only be used to copy or play contents that are notcopyrighted or contents for which copying or playback is legallypermitted for your private use as an individual. Be sure to complywith applicable copyright legislation.1 Make the necessary preparations.q Set the iPod in the DENON control dock for iPod.(vSee the control dock for iPod’s operating instructions.)w Assign the control dock for iPod’s input.The input for the control dock for iPod is assigned to VCR bydefault.MENU : ”Input Setup” – “Assign” – ”iPod Dock”(vpage 39)2 Either turn or press [iPod] toselect the input source assigned in step 1-w above.(iPod screen)b If the screens above are not displayed, the iPod may not beproperly connected. Try connecting again.Basic OperationOK to disconnect.Playback ENTER uio pButton located on both the main unitand the remote control unit BUTTONButton only on the main unit