|
0Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting SpecificationsLast Function MemoryThis stores the settings as they were directly before the standbymode was set.When the power is turned back on, the settings are restored to asthey were directly before the standby mode was set.Backup MemoryThe various settings are backed up for about 1 week, even if thepower is turned off or the power cord is disconnected.Resetting the MicroprocessorPerform this procedure if the display is abnormal or if operationscannot be performed.When the microprocessor is reset, all the settings are reset totheir default values.1 Turn off the power using .2 Press while simultaneously pressing and .3 Once the display starts flashing at intervals of about 1second, release the two buttons.If in step 3 the display does not flash at intervals of about 1 second,start over from step 1.Quick Select FunctionWith this function, the currently playing input source, input mode,surround mode, MultEQ XT settings and volume can be stored inthe memory.1 Set the input source, surround mode, MultEQ XT,Dynamic EQ, Dynamic Volume, Front Speakersettings and volume to the conditions you want tostore.2 Press and hold the desired QUICK SELECT until“Memory” appears on the display.The current settings will be memorized.• To call out the settings, press QUICK SELECT at which the desiredsettings were stored.• The Quick Select name can be changed (vpage 34).NOTEInput sources stored with the quick select function cannot be selectedif they have been deleted at menu “Manual Setup” – “Option Setup” –“Source Delete” (vpage 33). In this case, store them again.Input Source VolumeQuick Select 1 DVD –40 dBQuick Select 2 TV/CBL –40 dBQuick Select 3 VCR –40 dB[Quick Select Defaults]Personal Memory Plus FunctionThis function sets the settings (input mode, surround mode,HDMI output mode, MultEQ XT, Dynamic EQ, Dynamic Volume,audio delay etc.) last selected for the individual input sources.When you switch to an input source, the settings are automaticallyset to the ones that were set the last time that input source wasused.The surround parameters, tone settings and the volumes of thedifferent speakers are stored for the individual surround modes.Playback
|
