Graphic EQUses the graphic equalizer to adjust the tone of each speaker.0 Speakers for which “Graphic EQ” can be set differ according to the sound mode.0 This can be set when “MultEQ ® XT32” setting is “Off”. (v p. 180)0 This cannot be set when the sound mode is set to “Direct” or “Pure Direct”.0 If you are using headphones, you can set the equalizer for headphones.(v p. 183)o Graphic EQ / Headphone EQSet whether to use the graphic equalizer or not.On: Use the graphic equalizer.Off(Default): Do not use the graphic equalizer.0 “Headphone EQ” is set in the menu when headphones are used.o Speaker SelectionSelect whether to adjust tones for individual speakers or for allspeakers.All: Adjust all speaker tones together.Left/Right(Default):Adjust the left and right speaker tonestogether.Each: Adjust the tone for each speaker.o Adjust EQAdjust tonal balance for each frequency band.1. Select the speaker.2. Select the adjustment frequency band.63 Hz / 125 Hz / 250 Hz / 500 Hz / 1 kHz / 2 kHz / 4 kHz / 8 kHz /16 kHz3. Adjust the level.–20.0 dB – +6.0 dB (Default: 0.0 dB)0 Front Dolby, Surround Dolby and Back Dolby speakers can only be set when63 Hz/125 Hz/250 Hz/500 Hz/1 kHz.Contents Connections Playback Settings Tips Appendix183Front panel Display Rear panel Remote Index