Denon AVR-X4400H Manual

Also see for AVR-X4400H: Service manual Owner's manual

Contents

CrossoversSet in accordance with the lower limit frequency of the base frequenciesthat can be played back through each speaker. See the speaker manualfor information concerning speaker crossover frequency.o Speaker SelectionSelects how to set the crossover frequency.All(Default):Sets the same crossover frequency for allspeakers.Individual: Selects the crossover points for eachspeaker individually.o Set the crossover frequency40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz /200 Hz / 250 Hz (Default: 80 Hz)0 “Crossovers” can be set when the “Subwoofer Mode” setting is “LFE+Main”, orwhen you have a speaker that is set to “Small”. (v p. 231)0 The default crossover frequency is “80 Hz”, which will work best with thewidest variety of speakers. We recommend setting to a higher frequency thatthe crossover frequency when small speakers are used. For example, set to“250 Hz” when the frequency range of the speakers is 250 Hz – 20 kHz.0 Sound below the crossover frequency is cut off from the output of thespeakers set in “Small”. This cut off bass frequency is output from thesubwoofer or front speakers.0 The speakers that can be set when “Individual” is selected differ depending onto the “Subwoofer Mode” setting. (v p. 231)0 When “LFE” is selected, speakers set to “Small” at “Speaker Config.” can beset. If the speakers are set to “Large”, “Full Band” is displayed and thesetting cannot be made. (v p. 223)0 When “LFE+Main” is selected, speakers can be set regardless of the“Speaker Config.” setting. (v p. 223)Contents Connections Playback Settings Tips Appendix230Front panel Display Rear panel Remote Index