Denstply Sirona Sim Intego Operating Instructions Manual
                                                                                                                                        | |
Contents
| 
4 Operation4.4 Dentist elementDentsply SironaOperating Instructions Simulation Unit Sim Intego54 66 09 437 D3649D3649.201.01.04.02 06.20194.4.9.1 Switching Endo function on/offSwitching on the Endo functionThe Endo function is assigned to the burr drive removed from theholder.ü The desired electric motor for the Endo function is removed fromthe holder.ü The motor speed is shown on the EasyPad display.Purge➢ Press theEndo / Purge key.BÄ If the Endo function is switched on, theEndo function statusdisplay will illuminate.Ä The preset torque of 1.00 Ncm (Newton centimeters) isdisplayed on the EasyPad display.Switching off the Endo functionIf the Endo function is switched on, when the burr drive assigned to theEndo function is removed from the holder, the torque or speed of thecontra-angle handpiece is displayed instead of that of the motor on theEasyPad display. To show the motor speed again when the burr drive isremoved, the Endo function must first be switched off.Purge➢ Press theEndo / Purge key briefly (< 1 s).Ä TheEndo function status display goes out. When the burr driveis removed from the holder, the speed of the motor is shown onthe EasyPad display.4.4.9.2 Calibrating the burr driveCalibration is required when the integrated torque control is started,every time the contra-angle handpiece is changed, and every time thecontra-angle handpiece is lubricated. Recalibration is not necessarywhen a file is changed./An uncalibrated bur is marked with an "n" on the EasyPad display. Thebar above it indicates that the AutoReverse function is switched on, see"Switching the AutoReverse function on/off". If the auto-reverse functionis switched on, the burr drive automatically switches tocounterclockwise rotation when the torque set is reached.The contra-angle handpiece is automatically checked during calibration.This includes a measurement of motor current at different speeds toassess the properties of the system.CAUTIONTo ensure proper calibration, use only Dentsply Sirona instruments.ü Integrated torque control is switched on. The status displaytorquecontrol lights up.ü The torque is shown on the EasyPad display.1. Attach the contra-angle handpiece that you wish to use with torquecontrol to the electric motor. |
Related manuals for Denstply Sirona Sim Intego
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine