Eaton 9130 UPS User Manual

Also see for Powerware 9130: User guide User guide Specifications User guide Installation guide

Contents

COMMUNICATIONEaton® 9130 UPS (700–3000 VA) User's Guide 164201718 Rev 3 www.eaton.com/powerquality54Installing Communication Options and Control TerminalsTo install the communication options and control terminals:1. Install the appropriate connectivity card and/or necessary cable(s)and connect the cables to the appropriate location.See Figure 18 and the following section, “CommunicationOptions,” for detailed information.2. Route and tie the cable(s) out of the way.3. Continue to “Operation” on page 37 to start up the UPS.Communication OptionsThe Eaton 9130 has serial communication capabilities through the USBand RS-232 communication ports or through a connectivity card in theavailable communication bay.The UPS supports two serial communication devices according to thefollowing table:Independent MultiplexedCommunication Bay USB RS-232Any connectivity card Available Not in useAny connectivity card Not in use AvailableNOTE You can configure relays, signal inputs, and the serial port baud rate through thefront panel menus (see Table 3 on page 40).NOTE The communication speed of the USB port is fixed at 9600 bps.RS-232 and USB Communication PortsTo establish communication between the UPS and a computer, connectyour computer to one of the UPS communication ports using anappropriate communication cable (not supplied). See Figure 18 for thecommunication port locations.