Eaton CEAG ZB-S Mounting And Operating Instructions

223 Technical DataMounting and Operating Instructions CEAG Central Battery System ZB-S 40071860179 (L) November 2018 www.ceag.de3.16 Data Sheet for US-S/SOU2Type of system: ��US-S/SOU2Construction: ��Surface-mounted plastic distributorhousing of thermoplastic with transparentviewing doorHeight: ��458 mmWidth:��295 mmDepth: ��129 mmWeight :��approx� 8,8 kgInsulation class: ��IlDegree of protection: ��IP 65Colour : ��Grey (RAL 7032)Cable entry : ��from above (with integral elastic sealingmembranes for cable infeed, with cableinfeed shield)Hinge : ��leftMains rated voltage : ��230V AC, 50 or 60 HzBattery rated voltage : ��216V DCAmbient temperature operation : ��-5° C up to +35° CMains feed in (max� 16mm²) : ��X1�1Battery feed in (max� 16mm²) :��X1�5Max� 4 circuits (max�4 mm²)*:��X1�4Connection to RS485 Bus (max� 4 mm²)** :�X1�2RS485�A-BConnection to 24V analog output (max� 4 mm²)**: X1�3+24V Out--24V Out* Max� 2�5mm² flexible with wiring sleeve� The final circuits get wired customised�** Two strands to max� 0�5 mm² with twin wire end sleeve can be clamped in a clampspring terminal�3.17 Data Sheet for US-S/SOU1Type of system: ��US-S/SOU1Construction: ��Surface-mounted plastic distributorhousing of thermoplastic with transparentviewing doorHeight: ��458 mmWidth:��295 mmDepth: ��129 mmWeight :��approx� 7,5 kgInsulation class: ��IlDegree of protection: ��IP 65Colour : ��Grey (RAL 7032)Cable entry : ��from above(with integral elastic sealing membranesfor cable infeed, with cable infeed shield)Hinge : ��leftMains rated voltage : ��230V AC, 50 or 60 HzBattery rated voltage : ��216V DCAmbient temperature operation : ��-5° C up to +35° CMains feed in (max� 16mm²) : ��X1�1Battery feed in (max� 16mm²) :��X1�5Max� 2 circuits (max�4 mm²)*:��X1�4Connection to RS485 Bus (max� 4 mm²)** :�X1�2RS485�A-BConnection to 24V analog output (max� 4 mm²)**: X1�3+24V Out--24V Out* Max� 2�5mm² flexible with wiring sleeve� The final circuits get wired customised�** Two strands to max� 0�5 mm² with twin wire end sleeve can be clamped in a clampspring terminal�Mounting instructions: Small sub station1. Lock without key to be inserted from the rear into thehandle of the door fastening.2. Notch pin with the notch at the front to be pushed throughthe drilling at the door handle into the drilling of the lock.Final fixation with tool.