Eaton CEAG ZB-S Mounting And Operating Instructions

838 OperatingMounting and Operating Instructions CEAG Central Battery System ZB-S 40071860179 (L) November 2018 www.ceag.deSelect the system or fault messages onwhich relays 1 to 3 change over for sig-nalling contacts 1 to 3 (“picked up” and“dropped out” states).These settings can be used to send infor-mation about the operational status of thesystem to a control centre (e.g. with CEAGF3 remote indicator).A standard setting according to DIN VDE(see Appendix B) can be selected usingthe “Load defaults” option at the end ofthis menu. Select the relay number (1 to 3) withkeys  Highlight the events with keys  Select between relay switches ()and relay does not switch (no ) withthe key Finish and return to Menu 3 withActivating / deactivating the “Manualreset” option(see Menu 2.3 “Manual reset”) Toggle between “activated” and “de-activated” with  Finish and return to Menu 3 with Menu 3.6: Menu 3.8:Setting the time (1 ... 99 minutes) whichthe emergency light remains on after mainssupply is restored. Select 1 ... 99 minutes with the keys  Finish and return to Menu 3 with Menu 3.5:Date & timeFunctiontestDurationtestDelay time mains returnetc....FunctiontestDurationtestDelay time mains returnManual resetetc....Delay time mains returnManual resetSelective EmgcyOper.Relay setupetc....Manual resetdeactivatedDelay time on mainsreturn inminutes 10Activating / deactivating the “Selectiveemerg light” option Toggle between “activated” and “de-activated” with  Finish and return to Menu 3 with Menu 3.7:DurationtestDelay time mains returnManual resetSelective EmgcyOper.etc....ote:N See also menu option 1.9 “Relaystatus” in menu 1 “Test & statusmenu”.Selective emerg lightdeactivatedRelays 3Mains operationMains failure Mains failure MDB Charge faultCircuit faultLuminaire faultSum failureDeep discharge protectionISO failureFunction testBattery duration testDB-FÜBDevice failureInvert relaycontactLoad defaultsNOTE:With selective emergency light (only available in conjunction with DLS/3Ph bus mod-ules) each individual circuit must be assigned to a DLS/3Ph bus module to activatethe emergency light function. See Menu 5.4The functions «delay on mains return », «manual reset» and «selective emergencylighting» can be combined on circuits.Overview:Main menuTest & status menuBlock & reset alarmsBasic settingsDLS/TLS SetupCircuit setupLuminaire setupLogbooksetupSend ServicePinMsgMenu 3LanguageDate & timeFunctiontestDurationtestDelay time mainsreturnManual resetSelective EmgcyOper.Relay setupBuzzer setupDisplay setupCharger setupPrinter setupRelay module setupWebserver setupTimer setupSubstation setupConnection to BMSFunction keysOptional inputsSerialnumber & typePassword protectionDaylight saving timeService info Selection ofmenu optionswith thekeys  :confirm selec-tion : can-cel and returnto the previousmenu (anychanges en-tered are saved) : canceland return tothe previousmenu (anychanges en-tered are notsaved) flashing inputpromptAttention:Master / Salve mode and CG-Vision together dosn`t work