Eaton CEAG ZB-S Mounting And Operating Instructions

514 Construction and FunctionMounting and Operating Instructions CEAG Central Battery System ZB-S 40071860179 (L) November 2018 www.ceag.de4.4.10 External TLS-bus-moduleThis module monitors the switching status of buttons forup to two separate stairwell illuminations and transmittsthe particular switching status via a RS-485-busline to thecontroller of the system ZB-S.In mains and emergency operation the circuits of stairlightand emergency light will be operated according to thesettings for the controller CU CG-S! In addition to this,a supply of the switcher glow lamps of the connectedbuttons in mains and emergency operations occurs.Technical DataOO Mains supply for the modulesOO Device: 24 V DC (19 ... max. 30 V)OO Cable type: 4 x 2 x 0,8 mm IY(ST)Y, Twistet Pairscreended (minimum standard).OO Current consumption: max 50 mA, depending on thenumber of the connected glow lamps for stairwell-light switcherOO Bus connectionOO RS 485OO Rated current: Un = 24 V DCOO Cable type: 4 x 2 x 0,8 mm IY(ST)Y, Twistet Pairscreened (minimum standard).OO Connecting terminals A, B, SEOO 2 switching outputsOO Rated current Un = 230 VOO Switched current: max. 10 A (120 A/ms)ApplicationOO Assembly in the subdistribution board of the monitoredcircuits due to the low laying effort for the illuminationcircuits (compare «Mounting and Connection ofexternal bus modules»).OO Assembly in the control cabinet ZB-S (US-S) due toreasons for simplification of the maintenance (compare«Mounting and Connection of external bus modules»)OO Application-environmentProtection class / -category: IP20 / IAmbient temp.: -10 ... +40°C1 2 3 4 5Pos� 1: top connection terminalPos� 2: lower connection terminalPos� 3: Display-LEDsLED K1 resp� K2 lights up when the circuit is connected�LED T1 and T2 light up as long as the correspondingbutton-input is switched�LED Ein/On lights up when 24 V DC supply voltage ispresent and the device is activated over the controller�LED Störung/Failure lights up when a fault functionwas registrated by the modulePos� 4: Locking device button for a module attached toa 35 mm-DIN mountingrailPos� 5: Bus addressPlease install the relays K1 if the general lighting mustswitch on when the battery is disconnected:TLS-Bus-ModuleSafety lightingLight push-buttonGeneral lightingContact is closed atmains voltage fault andgeneral lighting is inmaintained mode�