Eaton COOPER POWER Series Installation And Operation Instructions Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Eaton COOPER POWER Series Installation And Operation Instructions Manual Manual pdf 18 page image

14 OPERATION AND INSTALLATION INSTRUCTIONS MN280075EN July 2018Form 6 microprocessor-based rack-mount recloser controlThe control is designed to be mounted in a standard 19"substation rack. There are three available mountingaccessories available:●● Double rack mount accessory with two handles and oneconnecting plate.●● Single rack mount accessory with two handles.●● Double rack – single mount accessory with two handlesand one filler plate.Refer to Accessories section of this manual for accessoryattachment instructions.CONTROL WEIGHT: 7 kg (15 lbs)otee:N Weight of one Form 6 rack mount recloser controlwith handles attached to both sides.19 (.75)229 (9)254 (10)38(1.5)184(7.25)222(8.75)220 (8.75)262 (10.25)245 (9.75).32 x .41 Dia. Mounting Holes (4)Grounding Terminal0.25 x 20 x 0.75 LGSide View Front View22 (.87)88 (3.5)88 (3.5)10-32 Tapped Holes3 Places on Each SideOptional Handles (2)CONTROL POWERCONTROL OKCONTROL LOCKOUTRECLOSER OPENRECLOSER CLOSEDA PHASE FAULTB PHASE FAULTC PHASE FAULTGROUND FAULTSENSITIVE GNDALARMABOVE MIN TRIPINDICATOR 1INDICATOR 2INDICATOR 3A PHASE VOLTAGEB PHASE VOLTAGEC PHASE VOLTAGEFREQUENCY TRIPVOLTAGE TRIPMETERINGRESETTARGETSEVENTSLAMP TESTMENUENTER+—SETTINGSOPERCOUNTERALARMSCHANGEF1 F2 F3 F4TRIP CLOSEHOT LINE TAGON GND TRIPBLOCKEDNONRECLOSINGSUPERVISORYOFFALTERNATIVEPROFILE #1ALTERNATIVEPROFILE #2ALTERNATIVEPROFILE #3RS-232 DATA PORTOPTION #1 OPTION #2 OPTION #3(LOCKOUT)INDICATOR 4INDICATOR 5INDICATOR 6INDICATOR 7INDICATOR 8CLOSE CIRCUITDISABLECOOPER POWERSERIESFigure 8 Form 6 rack mount recloser control weight and dimensionsGrounding the controlWARNINGHazardous voltage Recloser and control mustbe solidly grounded Follow all locally approvedprocedures and safety practices when grounding thisequipment Improper grounding can result in contactwith high voltage, which will cause death or severepersonal injury G115 1The Form 6 rack mount recloser control must be solidlygrounded prior to installation or energization. Refer toFigure 9 for grounding connections.otee:N Grounding of the mounting panel orstandard 19" rack does not eliminate the controlgrounding requirement.The grounding connection on the back of the control willaccommodate a spade connector or ring terminal that fitson a .25 inch diameter grounding terminal stud (Figure 10).otee:N Control grounding must comply with all locallyapproved procedures and safety practices that applyin a substation or other appropriate indoor facility.The recloser that the control will be connected to must alsobe properly grounded per the grounding requirements of theindividual recloser. Refer to the appropriate installation andoperation manual for grounding requirements.IMPORTANTAll external wiring inputs to the Form 6 recloser controlmust be routed within 8 inches of their correspondingground. During a surge, a potential of approximately 1.5kV per foot can develop in the conductors. Differencesbetween conductor and ground path lengths can addadditional stress to the control components in the event ofa power surge.