Eaton COOPER POWER Series Installation And Operation Instructions Manual

Also see for COOPER POWER SERIES: Installation and operation instructions Installation instructions Installation instructions Installation and operation instructions Operation instructions

Eaton COOPER POWER Series Installation And Operation Instructions Manual Manual pdf 31 page image

27OPERATION AND INSTALLATION INSTRUCTIONS MN280075EN July 2018Form 6 microprocessor-based rack-mount recloser controlAccessoriesThese accessories are available. Contact your Eatonrepresentative for additional information.Control cableThe control cable consists of two separate wire sizespending the distance from the Form 6 recloser controlto the selected Eaton Cooper Power series recloser. Thecontrol cable is fabricated with a connector on one endand pigtailed on the other. The connector is mated tothe recloser receptacle on one end and hardwired to thecontrol on the other end. Refer to Table 3 in the RecloserConnection/Control Cable section of this manual foravailable control cable lengths.Recloser interface junction boxThe recloser interface junction box (mounted on a reclosersubstation frame) facilitates customer wiring from therecloser to the control. The junction box is required whenthe distance between the recloser and control exceeds themaximum available control cable length for the KA85MEcontrol cable (Table 3).There are two types of junction boxes available:●● KME6-1811 The recloser interface junction box cable isfactory-hardwired between the recloser and the junctionbox. Refer to Figure 21, Figure 22, and Figure 25.●● KME6-1859 The recloser interface junction box cabledisconnects at both ends. The junction box has a malereceptacle that enables connection between the recloserand the junction box with existing control cables fromother Eaton Cooper Power series controls (Form 3A,Form 4C, etc.). Refer to Figure 23, Figure 24, andFigure 26.The junction box is mounted on the substation frame basedupon the mounting dimensions in Figure 21 or Figure 23.The junction box cabinet includes multiple diameter holesfor sealing grip connections to hardwire to the control.A recloser interface junction box cable connects fromthe junction box to the recloser (Figure 22 or Figure 24).Refer to Figure 25 or Figure 26 for control-to-junctionbox customer connection diagrams. Refer to Table 10 forcontrol-to-junction box cable requirements.203 mm(8.0 in)254 mm(10.0 in)1.062 dia. Hole forJunction Box Cable(factory-hardwired)1.312 dia. Hole(capped)152 mm(6.0 in) .312 diameterMounting Hole (4)109 mm(4.25 in)1.062 dia. Hole (2)(capped)273 mm(10.75 in)101.5 mm(4.0 in).41 diameterMounting Hole (2)292 mm(11.5 in)Figure 21 Form 6 recloser interface junction box KME6-1811 dimensions mm (in) (Dimensions are approximate )