Eaton DF6000 Application Manual

Also see for DF6000: Application guide Installation and operation manual

40 Amended: Jan 2014Ancillary DevicesDetectionStandard devices include Photoelectric, Ionisation (which will be obsolete by Dec 2007), Multimodeheat and the replacement for the Ion, the OptoThermal.The heat detector defaults to RoR when the panel is in Auto learn, these must be set to the requiredvalue RoR, BS (fixed 60 deg) or CS (fixed 78 deg) before upload or download to the laptop.The OptoThermal has both an optical smoke chamber and a heat element that work in tandem suchthat the smoke half becomes more sensitive when heat is also present.Each element will also work independently such that the heat is fixed temp 60 deg (A1S) and theoptical has slightly reduced sensitivity (but remains within the tolerances laid down by EN54).The OptoThermal and heat detectors are capable of responding to Day/Night programming describedon page 27Call pointsCall points are supplied as Surface, Flush mounted and IP 67 Weatherproof. Various accessories canbe fitted such as the hinged protective cover, recessing bezel and resettable plastic element.Generally the inputs of this device are used primarily for Fire, but the Input programming in SiteInstaller gives the options of setting them to fire, fault, reset, silence, pre-alarm and evacuate.A call point can also be used to initiate day night mode, isolate addresses or zones or be set to non-latching.SoundersSounders, beacons, sounder beacons all appear on the DF6000 device list as alarm/beacons and amaximum of 60 are allowed per loop, the panel and site installer treats them all the same forprogramming purposes.The site installer allows 3 stages for the device outputs and various options can be chosen at eachstage. Delays can ONLY be used on stage 1. (There is NO hierarchy on the stages whichever settingfulfils the requirement the sounder/beacon will comply with that setting)The settings i.e. sound or volume for the sounders can be done globally at the panel or individually onsite installer.Input/Output DevicesMIO1240 is a single input single output device. The output takes the form of a mains rated relaycapable of switching up to 8A.The Input spur is used to monitor a set of volt free contacts the end of line being 22k and a firingresistance of 5k6.Programming of the output has the same features as the sounder outputs. The Input programming isthe same as programming for the call point.