Eaton DF6000 Application Manual

Also see for DF6000: Application guide Installation and operation manual

64 Amended: Jan 2014FIG 5610. Load your .s32 file with the relevant program into PanelProg.exe. by clicking on the ‘open’tab.11. Click "update the panel".12. It may initially give you a timeout error, if so, just click "update the panel" again. The wholeprocess should take about 5 mins, it is important not to interrupt it.Site Installer – Upload FirmwareThe display software can now be updated using the later version Site Installer program (version2.5.26 or higher)FIG 57Click on ‘Commission’ ‘Upload Firmware and when the dialog box opens choose the required S32 fileand click ’Open’.The process is completely automatic – site installer deletes the old display and the sends the new file.NOTE This will take up to 5 mins so please ensure during the transfer the laptop does NOT gointo hibernate mode otherwise the display will become unrecoverable.Following the transfer the panel will run through a complete watchdog reset. At this point there mayhave been some changes to the existing settings within the menu structure such as applying orremoving delays etc, so in all cases an ‘Erase CDR’ must be carried out after upgrade.To achieve this remove the loop cables or loop cards (taking the appropriate precautions) and thenchoose ‘Erase CDR’. If the panel tries to do an Autolearn because of an empty or corrupt CDR at thispoint, no serious damage will occur because the loops are not connected.Simply reconnect or refit the loop cards (taking the appropriate precautions) and upload the programback to the panel.