29GREEN MOTION DC 44/66 EV CHARGER INSTALLATION MANUAL MN192006EN March 2023 www.eaton.com00Title7.3 How to start chargingTo start a charge, simply connect the appropriate charging cable to the car socket. Hold the RFID card in front of the reader.If the card is recognized, the LED starts flashing blue and then it shows the charge level (battery state of charge).Refer to the description in Chapter 7.4If the CHAdeMO plug is used, it is mandatory for the user to select the plug on the screen. Refer to Chapter 7.4If the card is not authorized, the charging session will not start and a red light is displayed on the EV charger status display.If the charging cable is disconnected from the car and there is no power consumption within two minutes, the user isautomatically de-authenticated.7.4 Indicators and User interfacesThe Green Motion DC 44/66 EV charger has three different indicator and user interface means, as shown in Chapter3.1:• LED indicators,• Color touchscreen display.• Emergency stop button7.4.2 LED indicatorGreen Motion DC 44/66 EV charger is equipped with a LED indicator located on the front cover (see Figure 1). Table 8summarizes the possible LED indications during the operation.Table 8. LED indications of Eaton Green Motion DC 44/66 EV chargerVisual indicator Description StatusGreen light on Ready for useFlashing green light Start-up stageBreathing green light Waiting for user interactionFlashing blue light Charging session start-upBreathing blue light Charging session in progressBlue light on Charging session completedBreathing orange light An update in progressRed light on Error in chargingYellow light on Charger is set to unavailableWhite + red dot flashing Network Error. EV charger cannotconnect to the internet/backendNo light Stopped or not poweredDuring charging, the LED indicator shows the state of charge of the vehicle, as illustrated in Figure 22.