Eaton Power Xpert Gateway Series 1000 Card User Manual

Also see for POW-R-COMMAND 1000: Instructions for the Use, Operation and Maintenance Instructions for the Use, Operation and Maintenance Quick start guide Installation and user manual Installation and user manual

Contents

GETTING STARTEDEATON Power Xpert® Gateway Series 1000 Card User’s Guide S 164201670 Rev 116Network ConfigurationIf you know the card’s IP address, you can configure the networksettings from the card’s Web page:1. Open a Web browser, type the IP address of the card, and selectGo.2. The login prompt appears. The user name and default password isuser for read-only information and admin for configuration(read/write) options. Log in as admin.The PXGX Series 1000 Card Web page opens (see Figure 18).Enter the Card’s IP AddressFigure 18. PXGX Series 1000 Card Web Page3. Select the Network link from the menu bar.The Network Configuration Settings page appears. The page showsthe current network status for each port on the card (greenindicates the network is connected; red indicates the network isdisconnected).4. You can enable or disable the DHCP control by activating ordeactivating the check box. The default is DHCP enabled.