Eaton Power Xpert Gateway Series 1000 Card User Manual

Also see for POW-R-COMMAND 1000: Instructions for the Use, Operation and Maintenance Instructions for the Use, Operation and Maintenance Quick start guide Installation and user manual Installation and user manual

Contents

CONFIGURING THE CARDEATON Power Xpert® Gateway Series 1000 Card User’s Guide S 164201670 Rev 1 21Setting the Date and TimeNOTE All selections are automatically converted to Coordinated Universal Time (UTC).To set the date and time:1. From the card’s Web page, click the Date/Time link from the menubar.The default is to synchronize the date and time from the PC clock.2. To synchronize the card with Network Time Protocol servers, selectSynchronize with NTP server(s) and type the IP addresses or hostnames. You can synchronize the card with up to three NTP servers.The NTP status is indicated in parentheses:S Not running – Indicates that NTP is not running.S Started, not synchronized – Indicates that NTP is running, but is notyet synchronized with an NTP server or controlling the localclock.S Synchronizing with NTP server – Indicates that NTP hassynchronized with the local clock, but is not yet synchronizedwith an NTP server.S Synchronized to XX, NTP stratum YY – Indicates that the card issynchronized with an NTP server at IP address XX that isoperating at NTP Stratum YY.NOTE When using host names, verify that the IP address of your network DNS Server isconfigured (see “Network Configuration” on page 16).NOTE When NTP status is Synchronized and there is a large discrepancy between thePXGX Series 1000 Card time and the actual time, it may take 5–30 minutes for NTP to resetthe card to the proper time.3. To set the time manually, select Set date/time manually and use thepull-down menus to select the local date in mm/dd/yyyy format andthe local time in hh/mm/ss format.