Eaton Power Xpert Gateway Series 1000 Card User Manual

Also see for POW-R-COMMAND 1000: Instructions for the Use, Operation and Maintenance Instructions for the Use, Operation and Maintenance Quick start guide Installation and user manual Installation and user manual

Contents

CONFIGURING THE CARDEATON Power Xpert® Gateway Series 1000 Card User’s Guide S 164201670 Rev 1 234. Click Apply and then OK to save the settings.5. Repeat Steps 3 and 4 for each additional trap recipient.To remove a trap recipient, click Delete Last. Click OK whenprompted to remove the settings for the trap recipient entered last.Restricting SNMP AccessTo limit access to the card from trusted SNMP NMS hosts only:1. From the card’s Web page, click the Access Control link from themenu bar.2. Activate the check box for SNMP access restricted by IP/hostname.3. Type the trusted NMS host’s IP addresses or host names,separated by a semi-colon, in the Trusted IPs/hostnames field.NOTE When using host names, verify that the IP address of your network DNS Server isconfigured (see “Network Configuration” on page 16).4. Click Apply and then OK to save the settings.System Location and System ContactTo set the system location and system contact:1. From the card’s Web page, click the Network link from the menubar.2. Enter the physical location of the installed Power Distribution Unit(PDU)/card (sysLocation string) in the System location field. Thisvalue also appears in the card’s Web page header bar.3. Enter the information to identify someone to contact with questionsabout this device (sysContact string) in the System contact field. Forexample, you can type a person’s name, phone number,department, e-mail address, physical location, or combination ofthese items, such as “John Smith x123”.4. Click Apply and then OK to save the settings.