Eaton Power Xpert Plus 1 Installation And Operation Manual

Also see for Power Xpert 9395: Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual

Contents

UPS SYSTEM INSTALLATIONPower Xpert 9395 UPS (450–550 kVA) Installation and Operation Manual 164201701 Rev 4 www.eaton.com/powerquality4-84. Locate the external wiring terminal hardware kit packed on the bottom left sideof the ISBM section.5. If installing a UPS with separate rectifier feeds, proceed to Step 6; otherwise,proceed to Step 8.NOTE On a UPS that is configured for separate rectifier inputs, all sources that feed the separate rectifierinputs must be derived from a common ground point.6. Connect phase A, B, and C rectifier input power wiring from the utility source toeach UPM rectifier input terminal block in the UPS cabinet. See paragraph 3.2.2on page 3-7, Table 3‐6 on page 3-11, and Table 3‐11 on page 3-13 for wiring andtermination requirements.Top Entry Conduit Landing for ACInput and Output, and DC Input(Remove panel to drill or punchconduit holes.)TOP VIEW Interface Entry Conduit Landings for TB1through TB3 Wiring and X-Slot Connections(Remove panels to drill or punch conduit holes.)Ventilation Grill Debris Shield(Remove shield before operating system.)Bottom Entry Conduit Landing for ACInput and Output, and DC Input(Remove panel to drill or punchconduit holes.)BOTTOM VIEWFrontFrontFigure 4‐4. Conduit and Wire Entry Locations