Eaton Powerware Series User Manual

Also see for Powerware Series: Installation and operation manual User guide User guide User guide User guide

INSTALLATIONEATON Power Distribution Rack (208V) User’s Guide 164201720 Rev 1 www.powerware.com 9Unpacking the CabinetC A U T I O N Only qualified personnel should be permitted to perform any work associated with this equipment. Unpacking the cabinet in a low−temperature environment may cause condensation to occur in and on thecabinet. Do not install the cabinet until the inside and outside of the cabinet are absolutely dry (risk ofelectric shock). The cabinet is heavy (see page 43). Removing the cabinet from its packaging requires a minimum of threepeople. Do not install a damaged cabinet. Report any damage to the carrier and contact your servicerepresentative immediately.Do not remove protective packaging until the equipment is ready for installation.To unpack the cabinet:1. Carefully inspect the outer packaging for evidence of damage during transit.2. Move the packaged cabinet as near as possible to its final location.3. Remove the outer layer of shrinkwrap.4. Remove the ramp packaged next to the cabinet and retain for later use to roll thecabinet off the pallet.5. Remove the inner layer of shrinkwrap and the large cardboard corner posts.6. Remove the large plastic bag covering the cabinet.7. Remove the accessory kit box from beside the cabinet.C A U T I O N The cabinet may roll when resting on its casters. Take proper care to secure the cabinet and ensure thesafety of personnel. Do not stand on or in the cabinet. The cabinet may tip and cause serious injury. Do not work on or in thecabinet until the leveling feet are in place.8. The cabinet is bolted to the pallet in four places with heavy−duty anchoring feet.Using care to verify that the cabinet does not roll on its casters, use a 14 mmsocket and socket wrench to remove the anchoring hardware.9. Verify that the installed leveling feet are retracted sufficiently to allow the cabinetto move easily.10. Place the supplied ramp next to the pallet, inserting the two hooks on the top ofthe ramp into the holes near the top edge of the pallet. Verify the ramp is firmlyand securely seated.11. Carefully roll the cabinet off the pallet. Use three people to ensure the cabinetdoes not tip.12. Discard or recycle the pallet and packaging in a responsible manner, or storethem for future use.