OPERATIONEATON Power Distribution Rack (208V) User’s Guide 164201720 Rev 1 www.powerware.com38Setup OptionsAccess to setup options is restricted to three System Setup Levels: 0, 1, or 2. Thehigher the level, the more setup options are available. Options on System SetupLevel 0 do not require password access.Table 8. Setup OptionsMinimumLevel* Description Available Settings Default Setting0 Enter Password Use the arrow keys to enter the password for the level you want toaccess, then select DONE to display the options for the setup level.Level 1: L1Level 2: Contact your servicerepresentative0 Versions Read only Current firmware versionsinstalled0 Contrast Adjust Adjust screen contrast with left/right arrow buttons 10%1 Log Out Exit the Level 1 or Level 2 setup options and display the Level 0setup optionsNone1 Change Access Level Password Change the password for the current setup levelUse the arrow keys to enter the new password (A–Z, 0–9, –, blank),then select DONE to save the new password.None1 Set Date and Time Set Month, Date, Year (mm/dd/yyyy)Set Hour, Minute (Time is a 24−hour clock.)00/00/000000:001 Clear History Clear the History Log None1 Clear Load Profile Clear the Load Profile None1 THD Alarm Level Set the voltage and current Total Harmonic Distortion for Input 1and Input 2, and enable or disable this feature:THD settingsEnabled/Disabled5.0Disabled2 Unit Type Read only: Model / CTO / Serial Factory−set identifiers2 Unit Name Up to 20 characters (A–Z, 0–9, –, blank) EATON EMS−PDR2 Reset All lower Level Passwords Reset the Level 1 password to the default setting None* Minimum System Setup Level required to access the setup option.Surge Protection OptionThe optional Transient Voltage Surge Suppression / Surge Protective Device(TVSS/SPD) has three status indicators (see Figure 23) visible through a slot near thebottom of the interior barrier protecting the panelboard. The PDR provides up to fourTVSS/SPD devices, depending on configuration. For TVSS/SPD specification details,see Table 14 on page 44.NOTE Phase status generated by the TVSS/SPD is communicated through the TVSS/SPD status indicators,not through the display.POWER APPLIED TO PHASES(green indicators illuminated)Figure 23. TVSS/SPD Indicators