63InStALLAtIon And opErAtIon mAnuAL 25-13741-E January 2020 www.eaton.com11. Commissioning11.5 Configuration FilesVoCALL 16 enables saving configuration parameters of the system as a record.Configuration files are stored on SD card.Steps to save the configuration are as below:1. Login as ‘EnGInEEr 2’.2. Go to option ‘Install.’ [#11]. Press ‘Accept’ .3. Go to option ‘Config. Backup/restore’. Press ‘Accept’ .4. Select option ‘Config. Backup’. Press ‘Accept’ .5. Panel will create and store the configuration file on SD card. The filename willbe date and time stamped.ote:n It is recommended to save the configuration to SD Card once the installationand configuration is complete or when any changes are made tosystem settings.ote:n The configuration file will be required to view logs stored on the SD cardusing the log viewer application.The saved configuration file can be used to restore the system configuration to anearlier state. This can help in saving installation time when any device – panel oroutstation is replaced.Steps to restore settings from an earlier stored config file.1. Login as ‘EnGInEEr 2’.2. Go to option ‘Install.’ [#11]. Press ‘Accept’ .3. Go to option ‘Config. Backup/restore’. Press ‘Accept’ .4. Select option ‘Config. restore’. Press ‘Accept’ .5. Select the file. Press ‘Accept’ .6. Select the parameters to restore. Panel will undergo power cycle once restoreprocess is completed.1 3 4 5 6 7 81 3 4 5 6 7 8 10 11 12 13 14 15 1610 11 12 13 14 15 1622 991 3 4 5 6 7 81 3 4 5 6 7 8 10 1110 1122 991 3 4 5 6 7 81 3 4 5 6 7 8 10 11 12 13 14 1510 11 12 13 14 1522 991 3 4 5 6 7 81 3 4 5 6 7 8 10 11 12 13 14 15 1610 11 12 13 14 15 1622 991 3 4 5 6 7 81 3 4 5 6 7 8 10 1110 1122 991 3 4 5 6 7 81 3 4 5 6 7 8 10 11 12 13 14 1510 11 12 13 14 1522 991 3 4 5 6 7 81 3 4 5 6 7 8 10 11 12 13 14 15 1610 11 12 13 14 15 1622 99Install1 System Settings2 Names3 Outstation Learn4 Update Software5 Config. Backup / Restore6 Factory Defaults(5-6)