CHAPTER 4: INTERFACES FLEXLOGIC DESIGN USING ENGINEERB90 LOW IMPEDANCE BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL 4-8544.4.7.4 Advanced Actions toolbarOnly basic objects (lines, rectangles, ellipses) can be rotated and flipped.Only objects from the Drawing Toolbar can be structured (grouped, ungrouped, forward, backward).Same Size Set the width and height of the selected components to the same width and height ofthe reference componentNudge Up, Down, Left, Right Moves selected component one pixel upward, downward, left, rightRotate Rotates selected component freely. Once selected, put your mouse cursor over thecomponent and move the component clockwise or counter-clockwise depending onwhat you need.Rotate Left, Right Rotates selected component 90 degrees counter-clockwise or clockwiseFlip Vertical Flips the selected component on the vertical axisFlip Horizontal Flips the selected component on the horizontal axisGroup, Ungroup Combines all selected components into one combined entity. Ungroups them intoseparate components.Front, Back Moves current components to the absolute front or back of all viewable layersForward, Backward Moves current components on layer higher or lower than its original layer hierarchy
