GE Multilin C60 Breaker Management Relay 4-134 HUMAN INTERFACES 4.2 FACEPLATE INTERFACE4d) ACTIVATING THE RELAYTo change the RELAY SETTINGS: "Not Programmed" mode to "Programmed", proceed as follows:1. Press the key until the SETTINGS header flashes momentarily and the SETTINGS PRODUCT SETUP messageappears on the display.2. Press the MESSAGE key until the PASSWORD SECURITY message appears on the display.3. Press the MESSAGE key until the INSTALLATION message appears on the display.4. Press the MESSAGE key until the RELAY SETTINGS: Not Programmed message is displayed.5. After the RELAY SETTINGS: Not Programmed message appears on the display, press the VALUE key or the VALUEkey to change the selection to "Programmed".6. Press the key.7. When the "NEW SETTING HAS BEEN STORED" message appears, the relay will be in "Programmed" state and theIN SERVICE indicator will turn on.e) ENTERING INITIAL PASSWORDSTo enter the initial SETTING (or COMMAND) PASSWORD, proceed as follows:1. Press the key until the 'SETTINGS' header flashes momentarily and the ëSETTINGS PRODUCT SETUPí mes-sage appears on the display.2. Press the MESSAGE key until the ëACCESS LEVEL:í message appears on the display.RELAY SETTINGS:Not ProgrammedWhen the relay is powered up, the TROUBLE indicator will be on, the IN SERVICEindicator off, and this message displayed. This indicates that the relay is in the "NotProgrammed" state and is safeguarding (output relays blocked) against the installationof a relay whose settings have not been entered. This message will remain until therelay is explicitly put in the "Programmed" state.SETTINGS"## SETTINGS## PRODUCT SETUP# PASSWORD# SECURITY# DISPLAY# PROPERTIES# COMMUNICATIONS#↓# USER-DEFINABLE# DISPLAYS# INSTALLATION#RELAY SETTINGS:Not ProgrammedRELAY SETTINGS:Not ProgrammedRELAY SETTINGS:ProgrammedNEW SETTINGHAS BEEN STOREDwww . ElectricalPartManuals . com
