4-28 F60 Feeder Protection System GE Multilin4.2 FACEPLATE INTERFACE 4 HUMAN INTERFACES4Local access is defined as any access to settings or commands via the faceplate interface. This includes both keypad entryand the faceplate RS232 connection. Remote access is defined as any access to settings or commands via any rear com-munications port. This includes both Ethernet and RS485 connections. Any changes to the local or remote passwordsenables this functionality.To enter the initial setting (or command) password, proceed as follows:1. Press the MENU key until the SETTINGS header flashes momentarily and the PRODUCT SETUP message appears on thedisplay.2. Press the MESSAGE RIGHT key until the ACCESS LEVEL message appears on the display.3. Press the MESSAGE DOWN key until the CHANGE LOCAL PASSWORDS message appears on the display.4. Press the MESSAGE RIGHT key until the CHANGE SETTING PASSWORD or CHANGE COMMAND PASSWORD messageappears on the display.5. After the CHANGE...PASSWORD message appears on the display, press the VALUE UP or DOWN key to change theselection to “Yes”.6. Press the ENTER key and the display will prompt you to ENTER NEW PASSWORD.7. Type in a numerical password (up to 10 characters) and press the ENTER key.8. When the VERIFY NEW PASSWORD is displayed, re-type in the same password and press ENTER.9. When the NEW PASSWORD HAS BEEN STORED message appears, your new Setting (or Command) Password will beactive.f) CHANGING EXISTING PASSWORDTo change an existing password, follow the instructions in the previous section with the following exception. A message willprompt you to type in the existing password (for each security level) before a new password can be entered.In the event that a password has been lost (forgotten), submit the corresponding encrypted password from the PASSWORDSECURITY menu to the Factory for decoding.g) INVALID PASSWORD ENTRYWhen an incorrect command or setting password has been entered via the faceplate interface three times within a 3-minutetime span, the LOCAL ACCESS DENIED FlexLogic™ operand will be set to “On” and the F60 will not allow settings or com-mand level access via the faceplate interface for the next five minutes, or in the event that an incorrect Command Or Set- PASSWORD SECURITYACCESS LEVEL:Restricted CHANGE LOCAL PASSWORDSCHANGE COMMANDPASSWORD: NoCHANGE SETTINGPASSWORD: NoENCRYPTED COMMANDPASSWORD: ---------ENCRYPTED SETTINGPASSWORD: ---------CHANGE SETTINGPASSWORD: NoCHANGE SETTINGPASSWORD: YesENTER NEWPASSWORD: ##########VERIFY NEWPASSWORD: ##########NEW PASSWORDHAS BEEN STORED
