GE JCBP79 Owner's Manual And Installation Instructions

Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions1 2 3MIN MED MAX 4 56 7 8 9 0STARTDÉPARTSTARTDÉPARTCLEANNETTOYAGE22Wipe up heavy soil on the ovenbottom.Using the self-cleaning oven.The oven door must be closed and all controls set correctly for the cycle to work properly.Before a Clean CycleWe recommend venting your kitchenwith an open window or using aventilation fan or hood during thefirst self-clean cycle.Remove the broiler pan, broiler grid,all cookware and any aluminum foilfrom the oven.NOTE: : If your oven is equipped with grayporcelain-coated oven racks, they may beleft in the oven during the self-cleancycle.Soil on the front frame of the range andoutside the gasket on the door will needto be cleaned by hand. Clean these areaswith hot water, soap-filled steel-wool padsor cleansers such as Soft Scrub®. Rinsewell with clean water and dry.Do not clean the gasket. The fiberglassmaterial of the oven door gasket cannotwithstand abrasion. It is essential for thegasket to remain intact. If you notice itbecoming worn or frayed, replace it.Wipe up any heavy spillovers on theoven bottom.Make sure the oven light bulb cover isin place and the oven light is off.IMPORTANT: The health of some birds isextremely sensitive to the fumes given off duringthe self-cleaning cycle of any range. Move birdsto another well- ventilated room.How to Set the Oven for CleaningWARNING: The surfaceunits are automatically disabled duringthe self-clean cycle. Make sure that allsurface unit controls are turned off at alltimes during the self-clean cycle. Anysurface unit that is set to an on position,while the self-clean cycle is operating, willautomatically come on after the self-cleancycle is finished, and could result in anon, unattended surface unit. Wait untilthe self-clean cycle is finished to set anduse the surface units.Touch the CLEAN pad.Using the number pads, enter thedesired clean time, if a time otherthan 4 hours, 20 minutes is needed.Clean cycle time is normally 4 hours, 30minutes. You can change the clean timeto any time between 3 hours and 5 hours,depending on how dirty your oven is.Touch the START pad.The door locks automatically. The displaywill show the clean time remaining. It willnot be possible to open the oven dooruntil the temperature drops below thelock temperature and the LOCKED lightgoes off.When the LOCKED light goes off, you willbe able to open the door. The words LOCK DOOR will flash if youset the clean cycle and forget to closethe oven door. To stop a clean cycle, touch the OFFpad. When the LOCKED light goes off,indicating the oven has cooled belowthe locking temperature, youwill be able to open the door.