GE JCBP79 Owner's Manual And Installation Instructions

28Care and cleaning of the range.Be sure all controls are off and all surfaces are cool before cleaning any part of the range.If your range is removed for cleaning, servicing or any reason, be sure the anti-tipdevice is re-engaged properly when the range is replaced. Failure to take thisprecaution could result in tipping of the range and cause injury.Oven VentThe oven vent is located above the right rearsurface unit.This area could become hot duringoven use.It is normal for steam to come out ofthe vent.The vent is important for proper air circulation.Never block this vent.Control PanelIf desired, the touch pads may be deactivatedbefore cleaning.See the Oven Lockout information in theSpecial features of your oven control sectionin this manual.Clean up splatters with a damp cloth.You may also use a glass cleaner.Remove heavier soil with warm soapywater. Do not use abrasives of any kind.Reactivate the touch pads after cleaning.Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety InstructionsHow to Remove Protective Shipping Film and Packaging TapeCarefully grasp a corner of the protectiveshipping film with your fingers and slowlypeel it from the appliance surface. Do notuse any sharp items to remove the film.Remove all of the film before using theappliance for the first time.To assure no damage is done to the finishof the product, the safest way to removethe adhesive from packaging tape on newappliances is an application of a householdliquid dishwashing detergent. Apply witha soft cloth and allow to soak.NOTE: The adhesive must be removed from allparts. It cannot be removed if it is baked on.Control KnobsThe control knobs may be removed for easiercleaning.Make sure the knobs are in the OFFpositions and pull them straight off thestems for cleaning.The knobs can be cleaned in adishwasher or they may also be washedwith soap and water. Make sure the insidesof the knobs are dry before replacing.Replace the knobs in the OFF positionto ensure proper placement.