Electromagnetic Compatibility (EMC)EMC Immunity Test (cont'd.)Immunity Test ComplianceTest LevelComplianceLevelElectromagneticEnvironment–GuidanceRadiated RF 3 V/m80 MHz to 2.5GHz@ 2 Hz mod.Multilink Leadset: 3.0 V/mValue Lead set:3.0 V/mKISS Lead set:1.0 V/mMultilink Lead Set:d = 1.2 √P 80 MHz to 800 MHzd = 2.3 √P 800 MHz to 2.5 GHzValue Lead Set:d = 1.2 √P 80 MHz to 800 MHzd = 2.3 √P 800 MHz to 2.5 GHzKISS Lead Set:d = 3.5 √P 80 MHz to 800 MHzd = 7 √P 800 MHz to 2.5 GHzRecommended separationdistance:where P is the maximum outputpower rating of the transmitterin watts (W) according to thetransmitter manufacturer, and dis the recommended separationdistance in meters (m).Field strengths from fixed RFtransmitters, as determined by anelectromagnetic site survey:ashould be less than thecompliance level in eachfrequency rangebInterference may occur in thevicinity of equipment marked withthe following symbol:NOTE:• At 80 MHz and 800 MHz, the higher frequency range applies.• These guidelines may not apply in all situations. Electromagnetic propagation isaffected by the reflection from structures, objects, and people.• aField strengths from fixed transmitters, such as base stations for radio(cellular/cordless) telephones and land mobile radio, AM and FM radio broadcast,and TV broadcast cannot be predicted theoretically with accuracy. To assess theelectromagnetic environment due to fixed RF transmitters, consider conducting anelectromagnetic site survey. If the measured field strength in the location in whichthe system is used exceeds the applicable RF compliance level listed in this table,observe the system to verify normal operation. If abnormal performance is observed,additional measures may be necessary, such as re-orienting or relocating the system.• Over the frequency range 150 KHz to 80 MHz, field strengths should be less than 3V/m for Multilink and Value Lead Sets, and less than 1 V/m for the KISS Lead Sets.2053535-003C MAC™ 2000 ECG Analysis System 169