5-122 F35 Multiple Feeder Protection System GE Multilin5.5 FLEXLOGIC 5 SETTINGS5Some operands can be re-named by the user. These are the names of the breakers in the breaker control feature, the ID(identification) of contact inputs, the ID of virtual inputs, and the ID of virtual outputs. If the user changes the default nameor ID of any of these operands, the assigned name will appear in the relay list of operands. The default names are shown inthe FlexLogic operands table above.The characteristics of the logic gates are tabulated below, and the operators available in FlexLogic are listed in the Flex-Logic operators table.TEMPERATUREMONITORTEMP MONITOR Asserted while the ambient temperature is greater than the maximumoperating temperature (80°C)USER-PROGRAMMABLEPUSHBUTTONSPUSHBUTTON 1 ONPUSHBUTTON 1 OFFANY PB ONPushbutton number 1 is in the “On” positionPushbutton number 1 is in the “Off” positionAny of twelve pushbuttons is in the “On” positionPUSHBUTTON 2 to 12 Same set of operands as PUSHBUTTON 1Table 5–13: FLEXLOGIC GATE CHARACTERISTICSGATES NUMBER OF INPUTS OUTPUT IS ‘1’ (= ON) IF...NOT 1 input is ‘0’OR 2 to 16 any input is ‘1’AND 2 to 16 all inputs are ‘1’NOR 2 to 16 all inputs are ‘0’NAND 2 to 16 any input is ‘0’XOR 2 only one input is ‘1’Table 5–12: F35 FLEXLOGIC OPERANDS (Sheet 7 of 7)OPERAND TYPE OPERAND SYNTAX OPERAND DESCRIPTION
