Gaggenau BS 471 Use And Care Manual

Also see for BS 470: Installation instructions Instruction manual Instruction manual Instruction manual

Contents

Gaggenau BS 471 Use And Care Manual Manual pdf 16 page image

16Completing initial set-up"Initial set-up complete. Please calibrate the appliancebefore first cooking" appears in the display.Confirm with ™.The appliance enters the standby mode and the standbydisplay appears. The appliance is now ready foroperation.Calibrate the appliance before steaming for the firsttime. The appliance sets the boiling point.CalibratingThe boiling point of water depends on barometricpressure. As air pressure drops with increasingelevation, the boiling point drops as well. Duringcalibration, the appliance sets the boiling point to thepressure conditions at the place where it is installed.It is important for the appliance to steam for 20 minutesat 212° F (100°C) without interruption. Do not open theappliance door during this time.Notes‒ Calibrate the appliance only when it is cold.‒ During calibration, the appliance generates moresteam than it normally would do.1 Set the function selector to S.2 Select "Basic settings" using the rotary selector.3 Touch the ™ symbol.4 Select "Calibration" using the rotary selector.5 Touch the % symbol.6 Remove all accessories from the oven interior andtouch the ™ symbol.7 The duration of 20:00 minutes appears. Touch I tostart calibration.Calibration begins. The elapsing time is shown on thedisplay.Note: Do not interrupt calibration. Do not turn thefunction selector. Do not open the appliance door.A message appears in the display once calibration hasended. Touch ™ to confirm and turn the functionselector to 0.After a removalRepeat calibration so that the appliance willautomatically adapt again to the new location.After resetting to factory settingsAfter resetting to factory settings in the basic settingsmenu the appliance has to be recalibrated.After a power failureThe appliance saves the calibration settings, even aftera power failure or a disconnection from the mains. Itneed not be recalibrated.Cleaning accessoriesBefore using accessories for the first time, thoroughlyclean them with hot soapy water and a soft dish cloth.,QLWLDOVHWXSFRPSOHWH3OHDVHFDOLEUDWHWKHDSSOLDQFHEHIRUHILUVWFRRNLQJ&DOLEUDWLRQ&$/&$/