Gaggenau BS 471 Use And Care Manual

Also see for BS 470: Installation instructions Instruction manual Instruction manual Instruction manual

Contents

Gaggenau BS 471 Use And Care Manual Manual pdf 40 page image

40Dispose of the empty cleaning cartridge in accordancewith regional regulations for household garbage.Causes of an unsatisfactory cleaning resultIf the cooking compartment is still not clean once thecleaning program has ended, use the table below tohelp you identify the causes. Then insert a new cleaningcartridge and start the cleaning program again.Drying programWith the drying program, you can dry the cookingcompartment after cleaning or after steaming.The drying program takes 20 minutes.Starting the drying program1 Remove accessories from the cookingcompartment. Wipe out the cooking compartment.Thoroughly remove residues of cleaner. Closeappliance door.2 Set the function selector to S. Select the dryingprogram with the rotary selector.3 The j symbol is displayed. Confirm with ™.4 The drying time of 20 minutes appears. Touch I tostart. The drying time elapses on the display. Thelamp in the cooking compartment stays off.5 A signal sounds after 20 minutes. A messageappears in the display. Confirm with ™.The drying program has ended. Allow the appliance tocool down. Then polish the cooking compartment andthe panel with a soft cloth.Possible cause SolutionLocking cap on thecleaning cartridgeThe locking cap has not beenremoved from the cleaning car-tridge.Once the cleaning program has fin-ished, remove the cartridge fromthe appliance. Do not reuse the car-tridge. Dispose of the cartridge inaccordance with the local regula-tions.9 WARNINGRisk of injuryTo prevent the cleaner fromcoming into contact with theskin or eyes, do not removethe locking cap from a spentcartridge.Wrong cartridge(descaling cartridge)Use only original cleaning car-tridges for the cleaning program.Drain filter not inserted The drain filter must remaininserted in the cooking compart-ment floor while the cleaning pro-gram is in progress.Power failure Following a power failure that lastslonger than 3 minutes, the cleaningprogram is ended with a short pro-gram.Heavy burnt-in dirt Run cleaning program again inorder to remove stubborn dirt.'U\LQJSURJUDPPH_