32 • Operational Reference Genie Monochrome Series-GigE Vision CameraRead Only ParametersParameter DescriptionDevice Vendor For the Genie Monochrome series, this is always DALSA.Device Model Name Displays the device model name (for example, Genie M640).Device Version Displays the device version.Firmware Version Displays the currently loaded firmware version.Device ID Displays the camera serial number.MAC Address Displays the unique MAC (Media Access Control) address of the Genie camera.User Set ParametersParameter DescriptionDevice User ID Specifies a user written ID, of up to 15 characters, for the Genie camera.By default, this field is set to the serial number of the camera.Power-up Configuration Click Setting to open the Power-up configuration dialog box which allows you to specifycamera power-up configuration. For more information, see "Power-up Configuration" on page32.Power-up ConfigurationThe Power-up configuration dialog allows you to specify the camera configuration to load when powering-up thecamera. The Genie camera flash memory contains two possible configuration settings; the Factory Default (neutralparameters and in free run mode), and a user-defined Camera Configuration 1. The Camera Power-upconfiguration drop-down list box allows you to select either the Factory Default or a user specified cameraconfiguration file. To save the current CamExpert settings to the camera user-defined (Camera Configuration)setting, click Save. To view in CamExpert a camera configuration file currently saved in the camera, select theconfiguration file in the Load configuration from Camera drop-down list, and click Load. See the parameter listbelow.
