Genie Nano-CL Series™ Nano-CL Installation • 27Nano-CL InstallationIf you are familiar with Camera Link cameras and Teledyne DALSA frame grabbers, follow thesesteps to quickly install and acquire images with Genie Nano-CL and the CamExpert tool providedwith Sapera LT in a Windows OS system.Quick Start (using a Teledyne DALSA Frame Grabber)• Install Sapera 8.31 (or later). Use the Full SDK version with support for Teledyne DALSA framegrabber boards.• Install the Teledyne DALSA frame grabber board along with its driver for 10-Tap 8-bit support.This will match the default firmware loaded in the Nano-CL.• Start CamExpert and configure frame buffer, data Taps, and frame rate parameters to matchthe Nano-CL model being used. Do not configure for an external trigger.• Connect the Nano-CL, preferably with camera link cables that support PoCL.• Enable PoCL by its frame grabber feature. Else connect power to the Nano-CL via its I/Oconnector.• When the Nano-CL boots, CamExpert will read and display the camera features available withthat model.• Refer to the section Transport Layer Control Category to configure the camera’s camera linksettings.• The Nano-CL status LED has changed to flashing green, indicating it is in free runningacquisition mode. See LED States on Power Up for all status LED conditions.• From the Nano-CL Image Format Feature Category, select the Moving Grey Diagonal Ramp testpattern from the Test Image Selector Parameter.• Click grab. You will see the moving pattern in the CamExpert display window.• If a camera lens is attached, turn off the test pattern and grab live again. Adjust the lensaperture plus Focus, and/or adjust the Nano Exposure Time and frame rate as required.General Installation OverviewConnecting a Nano-CL to a frame grabber is similar whether using a Teledyne DALSA framegrabber board with Sapera LT SDK or a third party frame grabber with its own SDK.Teledyne DALSA has 2 application notes which cover in detail the installation of a Genie Nano-CL.From our web site http://www.teledynedalsa.com/imaging/knowledge-center/appnotes/ downloadone of these getting started guides as required:• See “G3-ANCL02-Getting Started with Genie Nano-CL and Teledyne Frame Grabbers.pdf”• See “G3-ANCL01-Getting Started with Genie Nano-CL and 3rd Party Frame Grabbers.pdf”Camera Firmware UpdatesUnder Windows, the user can upload new firmware, using the File Access Control features providedby the Sapera CamExpert tool.Download the latest firmware version released for any Nano-CL model from the Teledyne DALSAsupport web page: http://www.teledynedalsa.com/imaging/support/downloads/firmware/
