28 • Nano-CL Installation Genie Nano-CL Series™The Camera Works — Now WhatConsult this manual for detailed Nano-CL feature descriptions, as you write, debug and optimizeyour imaging application. Consult the frame grabber manual for all board control features.Nano-CL Connectors and Status LED OverviewConnectorsThe Nano-CL has three connectors:• A 10 pin I/O connector for camera power, plus trigger, strobe and general I/O signals. Theconnector supports a retention latch, while alternately the Nano-CL case supports using an I/Ocable with thumbscrews. Teledyne DALSA provides optional cables for purchase (seeAccessories). Also see 10-pin I/O Connector Details for pin out specifications.• Two standard miniature SDR-26 Camera Link connectors. Use a frame grabber with SDR-26connectors to simplify cabling. See Components Express Contact Information for a wide varietyof PoCL cables.• Note that these three connectors are identical on the two physical case sizes of the Nano-CLseries.The following figure of the Genie Nano-CL back end shows connector and LED locations. SeeMechanical Specifications — Nano-CL: for details on the connectors and camera mountingdimensions.Status LEDI/OConnectorGenie Nano-CL (medium casing) – Rear View
