September 2015 Service and Repair ManualSteer Axle ComponentsPart No. 1269074 S-80 • S-85 • S-80X 8111- 4 Steer Cyli nders11-4Steer CylindersHow to Remove a Steer CylinderThere are two identical steer cylinders that work inparallel. They are part of the same hydraulic circuit,but move in opposite directions. The tie rodcylinder maintains equal movement of the tires.Note: When removing a hose assembly or fitting,the O-ring (if equipped) on the fitting and/or hoseend must be replaced. All connections must betorqued to specification during installation. Refer toSpecifications, Hydraulic Hose and Fitting TorqueSpecifications.1 Tag, disconnect and plug the hydraulic hosesfrom the steer cylinder. Cap the fittings on thecylinder.Bodily injury hazard. Sprayinghydraulic oil can penetrate andburn skin. Loosen hydraulicconnections very slowly to allowthe oil pressure to dissipategradually. Do not allow oil tosquirt or spray.2 Remove the hose bracket mounting fasteneron the steer cylinder barrel-end pivot pin.3 Remove the pin retaining fasteners from thesteer cylinder pivot pins. Remove the pivot pinfrom each end of the steer cylinder.4 Remove the steering cylinder from themachine.
