Command Manual – MulticastH3C S3600 Series Ethernet Switches-Release 1510Chapter 2 Common IP Multicast ConfigurationCommands2-7ViewAny viewParameterinterface-type: Port type.interface-number: Port number.DescriptionUse the display multicast-source-deny command to display the configurationinformation about the multicast source port check.When you use this command to display the information,z If you specify neither the port type nor the port number, the multicast source portcheck information about all the ports on the switch is displayed.z If you specify the port type only, the multicast source port check information aboutall ports of this type is displayed.z If you specify both the port type and the port number, the multicast source portcheck information about the specified port is displayed.Example# Display the multicast source port suppression state of Ethernet1/0/1. display multicast-source-deny interface Ethernet 1/0/1Ethernet1/0/1 Multicast-source-deny disabled.2.1.6 multicast route-limitSyntaxmulticast route-limit limitundo multicast route-limitViewSystem viewParameterlimit: Limit on the capacity of the multicast routing table, in the range of 0 to 256.DescriptionUse the multicast route-limit command to limit the capacity of the multicast routingtable. The router will drop the protocol and data packets of the new (S, G) when the limitis reached.
