Command Manual – MulticastH3C S3600 Series Ethernet Switches-Release 1510 Chapter 6 PIM Configuration Commands6-3Related command: pim sm.Example# Configure the switch as a BSR with a priority of 2 (and the C-BSR address isdesignated as the IP address of VLAN-interface10).system-viewSystem View: return to User View with Ctrl+Z.[H3C] multicast routing-enable[H3C] pim[H3C-pim] c-bsr vlan-interface 10 24 26.1.3 c-rpSyntaxc-rp interface-type interface-number [ group-policy acl-number | prioritypriority-value ]*undo c-rp { interface-type interface-number | all }ViewPIM viewParameterinterface-type interface-number: VLAN interface whose IP address is advertised as acandidate RP address.acl-number: Number of the basic ACL that defines a group range. This range is theservice range of the advertised RP. The value ranges from 2,000 to 2,999.priority-value: Priority value of candidate RP, in the range of 0 to 255. The greater thevalue, the lower the priority levelall: Removes all candidate RP configurations.DescriptionUse the c-rp command to configure the router to advertise itself as a candidate RP.Use the undo c-rp command to remove the configuration.By default, no candidate RP is configured and the value of RP priority is 0.For the configuration of candidate RP, a relatively large bandwidth should be reservedfor the router and other devices in the PIM domain.Related command: c-bsr.
