Command Manual – MulticastH3C S3600 Series Ethernet Switches-Release 1510 Chapter 6 PIM Configuration Commands6-21[H3C-acl-basic-2000] rule permit source 10.10.1.2 0[H3C-acl-basic-2000] rule deny source 10.10.1.1 06.1.22 static-rpSyntaxstatic-rp rp-address [ acl-number ]undo static-rpViewPIM viewParameterrp-address: Static RP address. It must be a legal unicast IP address.acl-number: Basic ACL, used to control the range of multicast group served by static RP.Its value ranges from 2000 to 2999. If no ACL is specified upon configuration, static RPwill serve all multicast groups; if an ACL is specified, static RP will only serve themulticast group passing the ACL.DescriptionUse the static-rp command to configure static RP.Use the undo static-rp command to remove the configuration.Static RP functions as the backup of dynamic RP to improve network robustness. If theRP elected by BSR mechanism is valid, static RP will not work. All routers in the PIMdomain must be configured with this command and be specified with the same RPaddress.The new configuration overwrites the old one if you execute the command for a secondtime.Related command: display pim rp-info.Example# Configure 10.110.0.6 as a static RP.system-viewSystem View: return to User View with Ctrl+Z.[H3C] multicast routing-enable[H3C] pim[H3C-pim] static-rp 10.110.0.6
