Command Manual – MulticastH3C S3600 Series Ethernet Switches-Release 1510Chapter 2 Common IP Multicast ConfigurationCommands2-10# Enable the multicast source port suppression feature on Ethernet1/0/1 throughEthernet1/0/10 and on Ethernet1/0/12.[H3C] multicast-source-deny interface Ethernet 1/0/1 to Ethernet 1/0/10Ethernet 1/0/122.1.9 reset multicast forwarding-tableSyntaxreset multicast forwarding-table [ statistics ] { all | { group-address [ mask{ group-mask | group-mask-length } ] | source-address [ mask { source-mask |source-mask-length } ] | incoming-interface interface-type interface-number } * }ViewUser viewParameterstatistics: Clears the statistics information about MFC forwarding entries if thiskeyword is specified. If this keyword is not specified, MFC forwarding entries will becleared.all: Specifies all MFC forwarding entries.group-address: Group address.group-mask: Group address mask.group-mask-length: Length of group address mask.source-address: Source address.source-mask: Source address mask.source-mask-length: Length of source address mask.incoming-interface: Specifies the incoming interface of the forwarding entry.interface-type interface-number: VLAN interface type and VLAN interface number.DescriptionUse the reset multicast forwarding-table command to clear MFC forwarding entriesor the statistics about MFC forwarding entries.The order of the group-address argument and the source-address argument can bereversed. However, you must input valid group addresses and source addresses;otherwise, the system prompts an error.Related command: reset pim routing-table, reset multicast routing-table, displaymulticast forwarding-table.
