1-5display rmon historySyntaxdisplay rmon history [ interface-type interface-number ]ViewAny viewDefault Level1: Monitor levelParametersinterface-type interface-number: Specifies an interface by its type and number.DescriptionUse the display rmon history command to display RMON history control entry and history samplinginformation.After you have created history control entry on an interface, the system calculates the information of theinterface periodically and saves this information to the etherHistoryEntry table. You can use thiscommand to display the entries in this table.You can configure the number of history sampling records that can be displayed and the historysampling interval through the rmon history command.Related commands: rmon history.Examples# Display RMON history control entry and history sampling information for interface GigabitEthernet1/0/1. display rmon history GigabitEthernet 1/0/1HistoryControlEntry 1 owned by null is VALIDSamples interface : GigabitEthernet1/0/1Sampling interval : 10(sec) with 5 buckets maxSampled values of record 1 :dropevents : 0 , octets : 0packets : 0 , broadcast packets : 0multicast packets : 0 , CRC alignment errors : 0undersize packets : 0 , oversize packets : 0fragments : 0 , jabbers : 0collisions : 0 , utilization : 0Sampled values of record 2 :dropevents : 0 , octets : 0packets : 0 , broadcast packets : 0multicast packets : 0 , CRC alignment errors : 0undersize packets : 0 , oversize packets : 0fragments : 0 , jabbers : 0collisions : 0 , utilization : 0Sampled values of record 3 :
