ActilinoError MessagesPage 10613 Error MessagesThis section contains the error messages that can be displayed on the Actilino. Somemessages are always in English because they are not part of the message files. They comedirectly from the firmware because they have to be always available.13.1 English Language Error MessagesThese messages contain abbreviations which indicate the error status. Their meanings are:• FER (Fatal Error): A serious error has occurred.• ERR (Error): An error has occurred.• WRN (Warning): The system is notifying you about something that may require yourattention.13.1.1 Fatal ErrorsFatal errors may result in lost data if you do not proceed with caution. BEFORE you takeany further steps, please review chapter 11.1.2. It provides suggestions for saving as manyof your files as possible.Please act calmly — the Actilino will not take any action without your authorization!"FER: Message file not found."Cause: The current message file could not be opened.Remedy: The current message file must be reloaded."FER: Could not read MSG security header."Cause: In order to be able to unequivocally identify a message file, the file includesa security header at the beginning which provides various information. Thisheader could not be read correctly.Remedy: The current message file must be reloaded."FER: Invalid MsgId."Cause: A message was requested which is not contained in the current messagefile.Remedy: Please load the message files that match the currently used firmwareversion."FER: Invalid header ID in MSG file."Cause: The message file's security header containes invalid data.Remedy: The current message file must be reloaded."FER: Invalid size of message file header."Cause: The security header's size does not correspond to the size expected by thefirmware.Remedy: The current message file must be reloaded."FER: Invalid maximum length of messages."Cause: The maximum message length does not correspond to the maximum lengthexpected by the firmware.Remedy: The current message file must be reloaded."FER: Expected MSG version xx, found yy."Cause: The message file version does not correspond to the firmware version. Youmay receive this message when you have updated only the firmware code,but have not yet loaded the new message file.Remedy: Load the message files that match the current firmware.
